Installing Your Heater
WALL MOUNTING CONTINUED
Bracket shown above, located in position.
•
Carefully lift the heater up ensuring that the top rear ledge of heater engages with
the wall bracket and is sitting centrally. This process should be carried out by two
people to avoid injury or damage to property or the appliance.
•
Gently bring the heater down against the wall.
•
Mark the lower fixing bracket two fixing hole positions on the wall. Remove the
heater and drill the wall and insert the wall plugs.
•
Refit the heater to the wall and fasten the bottom fixing bracket to the wall using
the screws provided to permanently fix the heater in place.
SET UP
•
Unpack the pebbles from the bag and place them along the light unit in the desired
position.
•
Place the front surround over the front of the heater aligning the slots in the
brackets at each side of the front panel with the lugs on the sides of the heater.
Two people will be required for this operation.
•
Then fit the one-way screw into the hole on the bottom of the right lateral hook to
stop the front surround from being removed.
This appliance has been supplied with a
‘
1 way
screw’
for permanent installation of the
front surround. This is a safety requirement for the New Zealand and Australian
market.