General Care and Safety Guide
CONTENTS
1 x Goldair Ecosave panel heater
1 x Wall mounting accessories pack
2 x drill bits (1 x 7mm for plasterboard or wooden
walls, 1 x 8mm for drilling masonry)
4 x Rail fittings
4 x Screw bolts
4 x Bolt caps
NOTE: Please ensure you use the correct drill bit
for the wall surface material you are mounting on
to. Please contact your local hardware retailer or
builder for advice.
OVERVIEW OF YOUR GOLDAIR ECOSAVE
PANEL HEATER
Your Goldair Panel Heater will provide
background warmth.
Your Panel Heater is designed to take the chill off
the room.
The surface of this Panel Heater can be painted
with good quality paint (acrylic or enamel).
Note: Do not run power cord behind the heater.
To ensure the power cord is set to the closet
power socket, this heater can be rotated
clockwise and fixed to the wall in any 360degree
position, with the power cord in the corner closest
to the socket.
Decorating tip: All wall mounted heaters may
cause paint to discolour or wall paper to lift.
OPERATING INSTRUCTIONS
Before plugging in and using your new Goldair
panel heater, check all surfaces to ensure the
heater is not damaged in any way.
Check that the On/Off switch is set to the Off
position before plugging the heater into the mains
supply.
Use the On/Off switch along the side of the
heater to turn your heater on.
SAFETY FEATURE
In case of overheating, this heater is fitted with a
thermal fuse which is located inside the
construction of the heater. If this thermal fuse
activates it will turn the heater off however the
light in the power switch will remain on to let you
know there is still power going into the heater.
In the event that this happens, turn the heater off
at the switch and the wall socket and unplug it.
Then contact our Customer Service Team.
WARNING: Do not use this heater with a
separate programmer, remote-control system,
separate timer, or any other device that
switches the heater on automatically, since a
fire risk exists if the heater is covered or
positioned incorrectly.
CARE AND CLEANING
Do not attempt to dismantle the heater. There
are no user serviceable parts. For service or
repair, contact an authorised electrical service
technician.
Unplug the heater from the mains supply before
cleaning. Ensure that the heater has been
allowed to cool down completely before
cleaning.
To remove the unit from the wall, simply remove
the bolt caps, unscrew the bolts with a screw
driver and then take the heater down. Use a
vacuum cleaner to remove dust and fluff from
behind the heater.
The outside can be cleaned by wiping it over
with a soft dry cloth.
NOTE: Do not use abrasive cleaning agents or
polish, this can damage the surface and finish.
For short term non-use, simply turn off the unit
with the power switch on the side of the heater
and disconnect the mains power supply at the
wall.
IMPORTANT! NEVER COVER THIS HEATER!
CAUTION
This heater generates heat during use. Proper
precautions must be taken to prevent the risk
of
burns, scalds, fires or other damage to persons
.
WARNING Keep all objects at least 1 metre
from the front and sides of the appliance.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
Summary of Contents for GECO200 Ecosave
Page 1: ...GECO200 GECO201...
