Operating Your Heater
Cool Down Period - To assist in protecting the internal components, when the unit is
turned Off the fan will continue to blow room temperature air for a period of 30-60
seconds before shutting down to standby.
DO NOT TURN OFF AT THE WALL DURING
THIS TIME.
SAFETY DEVICES
This appliance has two protection devices:
•
Resettable Thermal Link - this will automatically disconnect the power to the
element at a pre-set overheat temperature. After cooling down it will reset and
power on again. If this occurs, investigate what is causing the appliance to
overheat.
•
Thermal Fuse - this disconnects the appliance permanently in case of overheating.
(It is non resettable).
CAUTION:
The appliance generates heat during use. Precautions must be
taken to prevent the risk of burns, scalds, fires or other damage to persons.
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble free operation:
•
Do not attempt to dismantle the heater.
•
There are no user serviceable parts. For service or repair, contact an authorised
electrical service technician.
•
Unplug the heater from the mains supply before cleaning.
•
Ensure that the heater has been allowed to cool down completely before cleaning.
•
The common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and
vacuum cleaning the air vents and grills.
•
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and
dirt.
•
Never use solutions such as petrol, thinners or polishing agents.
•
Ensure the heater is dry before plugging back into the mains supply.
SUPPORT AND TECHNICAL ADVICE
Goldair
–
New Zealand
Monday
–
Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
–
Australia
Monday
–
Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.
