Operating Instructions
Warnings & Safeguards
1. Children should be supervised to ensure they do not play with the timer.
2. This timer is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Operation (Pre-set function)
When you first turn the heated towel rail on, this will automatically use the
timer’s
pre-set
function.
Pre-set function - The heated towel rail will turn on and remain on for a period of 4 hours,
followed by 8 hours off.
Programming:
You can increase the ON period in increments of 1 hour by turning the heated towel rail off
at your switch then on again within 10 seconds of first turning the rail on. Each repetition
of this on/off sequence will increase the ON period by 1 hour (maximum of up to 11
hours).
If you would like to restore the pre-set 4-hour setting, discharge all the electricity and
power in the timer by turning the heated towel rail off for 60 seconds (this will clear the
memory).
To reset the timer, turn the heated towel rail on again.
Important Notes:
•
This timer must be installed by a licensed electrician in accordance with the Australia /
New Zealand Wiring Rules AS/NZS 3000 or the warranty will be voided
•
Do not megger test as this can damage the timer
•
The timer may not be installed with towel rails fitted with self-resetting or non-self-
resetting thermal cuts or protective devices (non-self-resetting) which can be reset by
disconnection of the mains supply.
•
The GBT100 timer is designed only to be used as a heated towel rail timer and should
not be used for any other purpose
•
The maximum load is 1000 Watts (resistive) at 220-240V ~ 50Hz
•
The timer is designed and should be installed and concealed behind the heated towel
rail’s switch in a typical wall cavity flush box.
•
There are no user serviceable internal parts in this product, and should damage or
malfunction occur, please return to the manufacturer for repair or replacement
•
Wiring size: 1.0-1.5mm²
•
All pole disconnection must be required in fixed wiring
