Assembly Procedure
Step 11.
Fitting Battery to Ignitor.
Unscrew the front of the ignitor button and insert AA - size battery (Alkaline recommended) into the
ignitor body ensuring the negative ( - ) end points inwards, refit the button. When ignitor spark is not
present or erratic, change the battery. If storing the BBQ for long periods, remove the battery.
Important: The hose must not be kinked.
Step 12.
The BBQ is intended to be used with a standard 9kg ULPG cylinder. This is the type of cylinder that
can be refilled at petrol station or swapped for similar cylinder.
Place the cylinder in position on the gas bottle bracket of the BBQ, under the left hand side burner,
so that the bracket sits through the neck of the cylinder, allowing it to hang.
Take the hose that came with the BBQ, check that it has a rubber seal on the regulator end of the
hose and connect this end to the gas cylinder, ensuring that the hose is not twisted. You
won’t need
a spanner here. Just turn the fitting in an anti clockwise direction and hand tighten as much as you
can. This should seal it sufficiently.
It is important to conduct a leak test prior to use. Follow leak test procedure.
(
Procedure
located on Page 2 of this manual)
Page 15
