Operating your Soup Maker/Blender, cont
Once unit is turned on and ready to use,
choose the function you require by
pressing the corresponding button on the
control panel.
The unit will beep 3 times to indicate the
cooking process has started.
When the cooking or blending is
completed, the unit will beep for several
seconds and the indicator light will flash.
If, during the cooking process, the
indicators blink and beep continuously,
something irregular has occurred:. Check
the following:
•
Lid is not properly locked
•
No liquid in the jug, triggering the over-
dry sensor
•
Jug is not properly placed in its main
body, triggering the safety micro-switch
•
Heating base and motor are over-
heated, triggering the overload sensor..
Separate jug and motor housing, let it
rest for 5 minutes to cool down.
•
Water or liquids exceed the MAXIMUM
level, triggering the overflow sensor
work. Water or liquid is less than the
MINIMUM level, triggering the
minimum
liquid safety sensor.
Note: Cooking times given are for
reference only.
GENERAL TIPS
Add your preferred liquid or stock to the
jug; all liquids and stocks used must be at
room temperature rather than warm or hot.
Make sure the total volume of ingredients
added is above the 0.3L minimum but not
more than 1.7L maximum. The internal
sensor near the base of the jug must be
covered with liquid; under filling the jug will
result in the alarm sounding and the unit
failing to operate. Should the boiling action
during cooking cause the hot contents to
reach the lid, the upper sensor will switch
off the heating function to help prevent
boiling over.
WARNING
: Food high in starch or sugar
content can burn onto the bottom element.
It is advisable to add these ingredients
through the food chute after the liquid has
already begun heating.
The cooking time for ingredients that have
been stored at a room temperature of 18°
is approximately 25-30 minutes, however
this is a guide only.
NOTE: the cooking sequences rely on
uninterrupted operation. Any
interruption will result in the
cancellation of the program. Restarting
will result in the cooking stages being
repeated which may affect the final
recipe.
Any ingredients to be added during the
cooking process can be added through the
food chute in the centre of the lid. Do not
unlock or remove the lid as this will stop
the program.
To completely stop the program at any
time, simply press the START/STOP
button.
Once the program has finished, the Soup
Maker/Blender unit will sound an alarm and
stop heating.
Your soup can be poured straight from the
jug but be careful when removing the lid
from the jug as it will be very hot.
WARNING: heat/steam will be emitted
from the lid. Care must be taken when
removing the lid and food chute.
