Goldacres Windrow MY18 2500L, Operator'S Manual

Page: 10 / 74

4 - Chapter 2 - Safety Windrow 2500L Operator’s Manual MY18 - REV 1
• Never attempt to siphon chemicals, or substances,
by sucking.
• It is imperative that the tow vehicle manufacturer’s
specifications be checked and all instructions for
use when transporting, or towing, be adhered to at
all times.
• Care should be taken when transferring liquid
into the tank to ensure that the gross weight
of the trailer does not exceed the braking and
carrying capacity as specified by the tow vehicle
manufacturer.
NOTE: 1 Litre water = 1 Kg.
• Water weighs 1kg per litre, however conversion
factors must be used when spraying liquids
that are heavier or lighter than water. Example:
liquid nitrogen has a density of 1.28 kg/L and will
therefore be significantly heavier than water if the
tank is filled completely. The total weight of a tank
full of chemical, should not exceed that of a full
tank of water. Machine damage can result if the
machine is over weight. See filling instructions in
Chapter 8 ‘Operation’ for more information.
• Consideration should be given to both the carrying
capacity of the trailer and the gradient of the
terrain when determining the speed at which the
tow vehicle can be driven safely.
• Ensure equipment is securely fastened or attached
to machine at all times.
• Never stand within the radius of the boom wings.
• Never work under any hydraulically raised boom.
Cautions
• A supply of fresh water should be with the
equipment at all times.
• Water tanks are not designed for use with diesel
fuel or any flammable liquid.
• Do not use this machine in ambient temperatures
exceeding 40 degrees Celsius.
• Ensure that all bolts are tightened and secured
before operation.
• Always ensure that the boom is securely supported
when travelling.
• Where fitted, care should be taken to never overfill
the diaphragm pump with oil or operate at speeds
exceeding 540 rpm.
• Do not exceed the maximum spraying pressure of
8 Bar.
Dangers
• Check area to be sprayed for overhead powerlines.
Contact between the machine and powerlines
can result in serious injury or death. If there are
powerlines in the spray area, exercise extreme
caution when tilting boom wings.
• Do NOT walk on machine platform when near
power lines.
Personal Protective Equipment
(PPE)
Always wear close fitting clothing and appropriate
safety equipment designed for the job at hand.
• Exposure to loud noise over an extended period
can cause permanent hearing impairment or loss.
Be active in the conservation of your hearing and
wear appropriate hearing protection at all times.
• Chemicals can be harmful to humans, appropriate
PPE should be used when handling chemicals.
CAUTION: Always refer to the chemical
manufacturers label for guidelines on the appropriate
PPE to use with the chemical/s you are using.
Goldacres also suggests that you read and understand
the following Australian standards:
• Australian Standard for Chemical
protective clothing AS3765.
• Australian Standard for Respiratory
protection devices AS1715.
Poisons Information Centres - Call 131 126 (AU)
Cuts, Stabs & Punctures
When Servicing machine, be mindful of sharp edges
on parts such as trimmed cable ties, hose clamps, cut
reinforced hose and the edges of plates and brackets
as they could cause cut, stab or puncture injuries.
Crush Hazard
Never attempt to maintain axles, wheels or
components within the vicinity of the wheels with the
tow vehicle running or in motion.
Pinch Hazard
When operating moving components such as the
boom, access ladder or other components, keep
fingers and hands away from potential pinch points.
Burn Hazard
• Avoid contact around all hydraulic lines when at
operating temperature
Entanglement Hazard
Rotating drives can cause serious injury or even death
when entanglement occurs. Keep hands, feet, hair and
clothing away from all moving parts to prevent injury.
Never operate this machine with covers, shrouds, or
guards removed.
Safety Information
Continued over page