ENG
ENG - 29
Note:
Although this product is fully compatibly with USB 1.1 & 2.0
Standards, a small percentage (about 5%) of USB flash drives might not be readable, due to
those USB-flash drive manufacturers non-compliance with the full (official) USB 1.1 / 2.0 Stan
-
dards.
Important:
this unit does not support USB-MP3 player, due to their inherent lack of software
compatibility. Only USB “pen drives” (flash memory USB drives) can be used, for MP3 playback.
Cassette tape playback
- Slide the function switch to the “tape (off)” position.
- Open the cassette door by pressing the “stop/eject” cassette button.
- Insert a pre-recorded cassette with the tape-side up, into the proper guide-rails on the inside
of the cassette door.
- Gently push the cassette door forward (inwards) to close it. Make sure the tape is fully and
properly inserted before doing so.
- Press the cassette-play button. This will start the playback. Note that the tape moves from
right to left.
- Adjust the volume to the desired level.
- The tape playback can be stopped at anytime, by pressing the “stop” button. At the tape’s
end, the set switches itself off automatically, and releases the play button at the same time.
- Press the “stop” button followed by the “rewind” or “fast-forward” button to rewind or forward
the tape at high speed.
Cassette tape recording
- Open the cassette door by pressing the “stop/eject” cassette button.
- Insert a blank cassette with the tape-side up, into the proper guiderails on the inside of the
cassette door.
- Gently push the cassette door forward (inwards) to close it. Make sure the tape is fully and
properly inserted before doing so.
- The set is now ready to start recording, which can be done from either the radio or CD-
player.
Recording from radio
- Slide the function switch to “radio” position.
- Tune in the desired station by turning the tuning knob.If necessary, extend the telescopic
antenna, and adjust position of the set to improve reception.
- Press the cassette play and record buttons together.
- Simply press the cassette stop button to stop recording.
Recording from CD, CD-MP3, USB-MP3 and SD-MP3
- Slide the function switch to “CD (CD-MP3/ USB-MP3/ SD-MP3)” position.
- Start to playback with the desired source as previously described.
- Press the cassette play and record buttons together to start recording.
- Simply press the cassette stop button to stop recording.
Summary of Contents for CDM699
Page 32: ......
