Deutsch |
2
English |
12
www.goebel-group.com
4. Tool operation (important tips before starting work)
•
Please charge the battery to 100% before first use (according to the relevant government regulations)
•
The function settings must be determined in advance according to the rivet specifications, sheet thickness and riveting
conditions (see page 10).
Very important, if the rivet mandrel container is more than two thirds full, it must be emptied in time,
otherwise the normal use of the tool may be impaired or the riveting tool may be destroyed! Note that after
determining the stroke, start riveting according to the set mode, riveting operation procedure as shown in the
following figure:
4.1 Riveting in conventional mode (D)
➀
Insert rivet into work piece.
➁
Insert nosepiece onto rivet mandrel.
➂
Pull the trigger
and start riveting.
➃
After riveting, the tool tilts back to let the broken residual man
-
drel fall into the collecting container
➄.
If the residual rivet mandrels in the collecting
container are more than 2/3, unscrew the collecting container, remove the residual rivet
mandrels and screw the collecting container back on.
4.2 Riveting in self-locking mode (S)
①
Load the rivet into the nosepiece.
②
Pull the trigger and lock the rivet mandrel.
③
Make sure the mandrel is locked and ready to rivet.
④
The rivets are inserted into the
work piece and you pull the trigger again.
⑤
After riveting, tilt the tool backwards and
allow the residual mandrel to fall into the collecting container.
⑥
If the mandrel
collecting container is more than 2/3 full of the mandrels, unscrew the container, remove
the mandrels and screw the container back on.
