GOEBEL Air Power 3, Operation Manual

Page: 15 / 32

2.3 Range of usage
The pneumatic-hydraulic tool is designed for riveting with blind rivets:
* Recommended nose-pieces with respect to rivet diameters (does not apply for all types of rivets)
2.4 Tool operation
The manufacturer equipped the tool with a nose-piece /fig.1 – pos.1/ for a rivet Ø 5,0. Riveting with
blind rivets of different diameters (further on referred to as BR) requires use of appropriate nose-
-pieces that are located in the accessories casing of the tool.
Replacement of nose-pieces: Connect the tool to the source of compressed air, depress the
trigger and screw out the nose-piece /fig.1 – pos.1/ with a spanner no. 12. Screw on a new
nose-piece /acc. to the chart/ and tighten it. Now you can release the trigger of the tool.
The tool is equipped with revolving air supply /fig.1 – pos.A75/ which enables manipulation with air
supply before as well as during tool operation, air hose does not obstruct riveting in any position.
The tool is equipped with multifunction trigger /fig.1 - pos.74/ which enables following:
1) Rotational movement of the trigger around the pin - riveting.
– The trigger is on the front extreme position, not pressed.
– Depressing the trigger shall fix the rivet.
Type of rivet Al (aluminium) St (steel) Rv (stainless
steel)
Recommended
nose-pieces*
standard Ø 4,8–Ø 5,0 Ø 4,8–Ø 5,0 Ø 4,8–Ø 5,0 nose-piece no. 5
standard Ø 6,0 Ø 6,0 Ø 6,0 nose-piece no. 6
standard Ø 6,4 Ø 6,4 Ø 6,4 nose-piece no. 6.4
structural - Ø 5,0 Ø 5,0
nose-piece 5 Monobolt
Fig.1
AIR POWER 3 ENGLISH
15
MAIN VALVE
structural - Ø 6,4 Ø 6,4
nose-piece 6.4 Monobolt