Godrej Minifresh 2000, User Manual

Page: 12 / 28

12
HEATING...
PLEASE RINSE..
Godrej Vending
WELCOME
ENJOY DRINK !!
TEMPORARY COUNT
TOTAL XXXXXX
TEMPORARY COUNT
BUTTON 1 XXXXXX
PERMANENT COUNT
TOTAL XXXXXX
PERMANENT COUNT
BUTTON 1 XXXXXX
VERSION X.X-XL
LEVEL:11 T:92°C
4 Operation
4.1
Introduction
The machine is extremely easy to operate. The display indicates
the status of the machine.

“HEATING...” indicates required water temperature
in the boiler is being achieved.

If 5300T machine is selected,
“INIT TEA BREWER” will appear when brewer is getting
Initialize to its rest position.

If Power ON Rinse is enabled, Machine asks for Rinse.

“WELCOME” indicates that the machine is ready to dispense.
A multi option keypad has been provided with direct flavour selection keys and the additional keys for
special functions like Rinsing, Hot Water, etc.
4.2
Taking products
If the machine is ready then drinks can be taken as follows:
Place a cup on the drip tray below the dispensing outlet.

Select the drink listed on the keypad.

Remove the cup when the message on the display
of “ENJOY DRINK !!” disappears.
4.3
Special function keys
There are some keys for special functions and system monitoring. The key functions are as follows:
1. Press the Function Key
f
n
for the following displays…
a.
Press “once” to display “TEMPORARY COUNT”, then
press the Flavour key immediately to read the current
counter reading of that flavour.
The counter reading can be made ZERO by pressing the key
“B”
at the back side of
the bezel to start the counting again.
b. Press
“twice” to display “PERMANENT COUNT”, then
press the Flavour key immediately to read the current
counter reading of that flavour.
The permanent counter reading cannot be made ZERO.
c. Press
“thrice” to display water level status inside the boiler. Firmware version is
displayed on the 1
st
line and Level & Temperature in 2
nd
line of display.
Level “11” means
water is filled up t
o the Upper level of boiler, “01” or “10” means water is filled up to
Lower level only. “00” means water level is very low and machine need water.
In this mode, the machine also displays the water temperature inside the boiler. “T 82”
means, water temperature is 82°C.
2. Press
R or Rinse
to rinse the mixers of a selected flavour. This helps to clean and check the
microbial growth inside the mixers.
To rinse a selected channel, press
R
or
Rinse
and press the desired flavour key immediately.
The selected flavour mixer will be rinsed with hot water and the machine will become ready for
dispensing the next drink.
INIT TEA BREWER