Notification
*Power off the printer and remove the cable from the electric socket before installing the cutter module.
*Labels with adhesive glue are not applicable or otherwise could result in malfunction.
*Applicable label size is at maximum width of 75mm and minimum length of 30mm.
(Use the labels with over this range will be excluded from warranty terms)
*Stop position (E value) should be set to 46 through GoLabel before using the cutter.
*After the cutter is installed, please send the following commands through Golabel to activate the high-speed cutting function.
^XSETCUT,MODE,0,1 → enables high
-speed cutting function
^XSET,SMARTBACK,1 → enables pre
-print function
^D1,280 → enables cutter function
*The label width setting should be 6mm wider than the original design → For example: the actual paper width is 35,
Command needs to set
^W41
*The horizontal displacement needs to be set to 48
*Before using the High-Speed Cutter, the antistatic brush needed to be installed on the printing mechanism.
TICKET TRAY
CONNECTION CABLE OF
CUTTER
COVER
The applicable F/W version is V2.100 or above
