DT2 / DT4 series User Manual
Safety instructions
Please read the following instructions carefully.
1.
Keep the equipment away from humidity.
2.
Before you connect the equipment to the power outlet, please check the voltage of the
power source.
3.
Make sure the printer is off before plugging the power connector into the power jack.
4.
It is recommended that you connect the printer to a surge protector to prevent possible
transient overvoltage damage.
5.
Be careful not to get liquid on the equipment to avoid electrical shock.
6.
For safety and warranty reasons, ONLY qualified service personnel should open the
equipment.
7.
Do not repair or adjust energized equipment under any circumstances.
CAUTION
Danger of explosion if battery is incorrectly replaced
Replace only with the equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
Only use with power supply adapter model: WDS060240P (9A).
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Specifications are subject to change without notice.
