6
REV.01
INSTALLATION INSTRUCTIONS
© 2016 Go Rhino Products. All rights reserved
STEP #7
Remove the retaining clips and stud plates from the factory receiver hitch, (Photo 7).
STEP #8
Cut and remove the bumper attachment flanges for the bumper end caps (driver and
passenger side), and the outlined area for the trailer plug mount from the factory receiver hitch,
(Photo 8).
Photo 7. Driver side.
Photo 8. Driver side.
BR20 BUMPER REPLACEMENT INSTALLATION
NOTE:
If you are replacing a bumper with rear Park Assist, the sensor detection zone will be
altered with use of this bumper replacement.
STEP #1
If the vehicle is equipped with rear Park Assist, remove each sensor from the bezel by
gently spreading the bezel tabs and pulling out on the back of the sensors. Note: Do not push on the
front of the sensor as this may damage the sensor.
STEP #2
Remove the sensor bezels from the factory bumper by depressing the (4) tabs around
the base and pushing the bezel out through the front of the bumper. Note: The sensors and bezels
have to be positioned in the replacement bumper in the same location (inner and outer), (driver
and passenger) as removed from the factory bumper.
STEP #3
On each side of the BR20.5 bumper, remove the (2) plastic plugs from the sensor bezel
brackets that are preinstalled in the bumper.
