5
REV.01
INSTALLATION INSTRUCTIONS
© 2016 Go Rhino Products. All rights reserved
Photo 3. Driver side.
Photo 4.
STEP #5
The factory bumper consists of (3) components. Begin by removing the plastic top pad
and center component from the bumper end caps by pulling up from the outside edge. To ease
removal, the plastic clips can be popped loose from the underside of the bumper end caps, (Photo
5).
STEP #6
Remove the bumper end caps by removing the (5) bolts securing each end cap to the
receiver hitch, (Photo 5).
The factory bumper consists of (3) components. Begin by removing the plastic top pad and center
component from the bumper ends by pulling up from the outside edge. To ease removal, the plastic
clips can be popped loose from the underside of the bumper ends, (Photo 5).
Photo 5. Driver side.
Photo 6. Driver side.
