4
REV.01
INSTALLATION INSTRUCTIONS
© 2016 Go Rhino Products. All rights reserved
OEM BUMPER REMOVAL.
STEP #1
Disconnect the factory bumper wiring harnesses from the vehicle wiring harness, (Photo
1).
STEP #2
Remove (2) tree clips and bolt securing the wiring harness ground wire to the frame,
(Photo 2).
Photo 1. Driver side.
Photo 2. Driver side.
STEP #3
With assistance support the rear bumper and remove the (3) nuts on each side of the
vehicle securing the factory bumper and receiver hitch to the frame. Remove the bumper from the
vehicle, (Photo 3).
STEP #4
Disconnect the license plate lights, trailer plug (Photo 4) and If equipped disconnect the
backup sensors from the factory bumper wiring harness. Remove the wiring harness from the
factory bumper.
