18
Step 9: Initial startup
Switch on the battery 07 on the left side at the on-off switch. The ONwheel system
starts and checks the 3 phases of the ONwheel motor and at successful test, three
signals sound for each phase, followed by the ‘go-e’ acoustic signal.
For performing of a motor and speed-sensor calibration it’s enough to drive a short
distance of 100m with a speed of 15 – 20 km/h by your bike. The ONwheel motor
gets automatically calibrated to your rear wheel size.
As second option you can activate the manually measurement of the rear wheel
diameter in the app. See section
Use of the ONwheel App
for more Info.
The ONwheel complete kit gets delivered with the factory setting of 250W and 25
km/h. In order to adjust the power/speed you need a smartphone with Bluetooth
and the go-e ONwheel app installed.
Step 8: Insert the battery into the battery holder
Insert the
battery 07
into the
battery holder 06
. The battery 07 should snap in to
the battery holder 06 completely.
The driving of your bike only with the Power Grip (accelerator thrott-
le) without pedaling, is not allowed in the most countries because of
legal reasons. Please inform yourself exactly, before you activate this
special setting in the go-e ONwheel app.
Step 7-1: Fixation of the optional Power Grip (accelerator throttle)
First remove your old grasps on your handlebar of your bike. Pull the left grasp over
the handlebar, then pull the Power Grip (accelerator grip) over the right side of the
handlebar and fasten the already mounted Allen screw of the Power Grip.
Remove the protecting cap from the 3.5mm jack on the left side of the Power But-
tons 03. You can plug in the Power Grip (accelerator throttle) into this jack.
The Power Buttons 03 will get deactivated when you plug in the Power Grip. Before
you plug in the Power Grip you have to switch to the power level 0 (Power Grip
mode) over the Power Buttons 03 and afterwards push through the plugged in Pow-
er Grip once in order to activate it.
For easier fixation of the grasps onto the handlebar, we recommend to
soap the grasp areas on the handlebar and of the inside of the grasps
with detergent.