16
Step 6: ONwheel Motor fixation
Put on the
ONwheel Motor 11
onto
the slide of the mounting plate 01 till it
locks imperceptible.
Unscrew the two screws of the lengt-
hwise adjustment of the mounting
plate 01. [P19] Now press the ONwheel
motor 11 with power towards the rear
wheel and at the same time fasten the
screws of the lengthwise adjustment.
[P20]
Check, if the drive roller of the ON-
wheel motor 11 is pressed enough
against the rear wheel. Ideally, the shell
of the rear wheel should get slightly
pushed in.
To check if the ONwheel motor 11 is
positioned correctly, hold the drive rol-
ler and try to rotate the rear wheel. The
rear wheel may not move.
Additionally, you can activate the auto-
matic switch-off at too much loss of tire
tread. For more info, see section
Use of
the ONwheel App.
ATTENTION
Don’t have the battery in switched-on state or inserted into the bat-
tery holder during the mounting in no circumstances!
Before mounting of the ONwheel motor 11, please ensure that the
rear wheel has enough tire pressure (see on tire imprint). Normally
that are 3 bar.
You have to readjust the ONwheel motor 11, when your rear wheel lo-
ses tire tread over the time or when you have mounted a new rear tire.
P19
P20
