GNATUS Syncrus G8, Owner'S Manual

Page: 24 / 36

24
Press the (A) key down, and the lever to
the right (B), together, will turn on the
high RPM air and water spray turbine.
A
Press key (A) down, will supply air
to the tips.
Press the key (B) to the right, to supply
air to the high RPM micro motor hand sets
(only air/ electric).
Put one foot under the transport
handle, to move it, lift it sufficiently and
place in the desired position.
Chip-blower system
The chip-blower system allows for the release of the airflow when the turbine is stopped (function of the
air). It has a double function key that allows for the operation of the hand set with or without water, as
shown below:
“Go back to the last position” and “Spitting Position”:
When pressing the button “Go back to the last position” “Spitting Position” (03), the light source
will turn off (if it was on), water will then flow in the basin (for the duration of the programmed
time or if this has not been programmed, for 4 minutes), the chair back will raise completely to
the Spitting Position, when pressing it again, the back support will return to the previous position
and the light source will turn on (if it was on). When pressing the button “Return to zero” (05), the
light source will turn off (if it was on), water will then flow in the basin (for the duration of the
programmed time or if this has not been programmed, for 4 minutes), the chair back will raise up
completely and the chair will go down completely.
After activating the “Return to zero” operation (05), or the “Return to the last position, “Spitting
Position” (03), or any other operation, this will operate “Stop”, and the current position of the chair
back will automatically be defined as the “Last position”.
A B
A
B
OPERATION OF EQUIPMENT