GNATUS EasySonic, Owner'S Manual

Page: 47 / 76

Problem Probable cause Solution
- Equipment inoperative. - ON/OFF Button in the OFF
position.
- Plug not connected to the
mains.
- Fuse burned out.
- Turn on the button.
- Connect the plug.
- Get into contact with the
Gnatus technical assistance.
- Lack of power on the Ultra-
sound.
-
Deformed insert.
- Loose insert.
- Wrong use (incorrect attack
angle).
- Substitute the insertion.
- Tighten the insertion with
the key.
- See item “Techniques and
applications”.
- No water flowing through
the Adjust the flow of water.
- Inadequate water supply
pressure.
- Bad adjustment of the
water.
- Solenoid valve damaged.
- Correct the water pressure.
- Adjust the flow of water
through the hand-operated
valve.
- Get in contact with Gnatus
Technical Assistance.
- Ultrasonic transducer gene-
rating too much heat.
- Low water flow. - Increase the water flow.
- Water flowing through the
equipment even after it’s
been turned off.
- Solenoid valve damaged. - Get in contact with the
Gnatus Technical Assistance.
- The equipment does not
work when the pedal is
activated.
- Failure in the proper working
of the pedal.
- Damaged pedal cable.
- Failure in the connection of
the pedal cable and control
unit.
- Get in contact with the
GnatusTechnical Assistance.
- Check the connection.
Upon coming across any problem in operation, follow the instructions below to check
and repair the problem, and/or get in touch with your representative.
UNFORESEEN EVENTS – SOLUTION OF PROBLEMS
47
In case of the equipment presents any abnormality; check if the problem is related
to some of the listed items under the item Unpredictable (situation, cause and
solution). If it’s not possible to solve the problem, shutdown the equipment and call
Gnatus’ technical assistance.