How to laminate
☞ Lamination
If the test lamination is acceptable, increase its speed for lamination.
Remarks : for the best embossing effect, we recommend 40㎛ Film for 150g papers
25㎛ Film for 200g papers.
※ This machine contains special speed and temperature control program to improve lamination quality.
1. Soft Accelerate System
- This program is to apply the change of the job speed within 4secs if the job speed is rapidly increased.
This delays the temperature decrease caused by the high speed rotation to prevent the low temperature that causes deterioration of laminating quality
2. Temperature control program
- the heater would be linked with speed to compensate the heat of the roller faster while the roller is on the job.
※ Notice for Lamination
1. Stop lamination could make a mark on a laminated results.
2. Basically, thicker substrates requires lower speed or higher temp.
3. Thinner substrates requires higher speed or lower temp.
4. For perfect lamination, similar materials lamination first and adjust the conditions for real lamination.
5. If substrate would not be fed properly, this could be a cause of wrinkle.
Start
(Speed 3)
KEY IN
(SPEED 13)
4sec
4sec
4sec
Example)
Starting job with a speed of 3 and increase the speed to 13
① The speed message will blink while changing the speed
② The message will no longer blink when the speed reaches
the set speed.
Remarks :
If the temperature of the roller is lower than the set temperature while increasing the speed, the speed will not increase from that point and "L-
TEMP" message will appear on the display. This message will be disappeared when the compensation of the temperature is made. Please increase the speed
again after
the "L-TEMP" message disappears.
41/60
