6. Error description
No Signal:
The red LED should be off for 1 second then
fl
ash. After 5 seconds, the red LED should be
OFF then waiting for the proper signal.
Low Battery:
The red LED should be off for 1 second then double
fl
ashes repeatedly.
Sensor Error:
it is automatically converted to sensorless mode, and you can check the error status
ONLY in the programmer.
High Temperature:
The red LED should be off for 1 second then 4times-
fl
ashes repeatedly.
Under the ESC connected to the programmer, max speed, average speed, max temperature, and
•
max currents can be seen on the screen of the programmer. Once the ESC is correctly connected
with the programmer, the previous traveling data is automatically removed. And, the after switching
on the ESC, if the throttle stick stays at the neutral position for over 5 seconds, the previous trave-
ling data is also automatically removed.
When doing factory setting, the motor type and stick position should stay as they are.
Please make sure the con
fi
guration between the ESC and the motor. Otherwise, it can damage the
•
ESC. You do need great care, especially when change
05
Manual Genius Race
Sensorless
Sensored
Brushed
Default
1 Motor Type
Brushless Sensorless (1) / Brushless Sensored (2) / Brushed (3)
Sensored
2 Battery Type
LiPo (1) / LiFe (2) / NiMh (NiCd) (3)
LiPo
3 Cut Off Voltage
Auto (1) / 3,0 V ~ 6,5 V (0,1 V Step)
Auto
4 Power Curve
Soft (1) / Linear (2) / Hard (3)
Linear
5 Advanced Timing
0`(1) ~ 25`(6) / 0 (1) ~ 10 (6)
25‘ / 10
6 Acceleration
Lowest (1) / Low / Normal / High / Highest (5)
Highest
7 Start Power
Lowest (1) / Low / Normal / High / Highest (5)
Lowest
8 Start Current Limiter
OFF, 10% (2) ~ 100% (11)
OFF
9 Current Limiter
OFF, 10% (2) ~ 100% (11)
OFF
10 Reverse Function
One Way (1) / Two Way 1 (2) / Two Way 2 (3)
Two Way (2)
11 Reverse Delay
0.2 s(1) / 0.5s / 0.8s / 1.3s / 1.8 s / 2.5 s (6)
2.5 s
12 M. Reverse Amount
20% (1) ~ 100%(9)
60%
13 Neutral Width
Narrow (1) / Normal (2) / Wide (3)
Normal
14 Speed Mixing Brake
0% (1) ~ 100% (11)
0%
15 A.B.S.-Brake
OFF (1) / Weakest / Weak / Normal / Strong / Strongest (6)
OFF
16 Auto Brake Amount
0 % (1) ~ 100% (11)
0%
17 Min. Brake Amount
0 % (1) ~ 100% (11)
30%
18 Max. Brake Amount
0 % (1) ~ 100% (11)
100%
19 Facory Setting
All parameters to be initialized as factory default values (2)
