CHAMP
3
TM
H
OT
M
ELT
G
LUE
G
UN
P
ART
#
C
HAMP
3
Glue Machinery Corporation
™
4234 Boston St, Baltimore, Maryland 21224
Toll Free 1-888-202-2468 | Phone: 410-761-2727 | Fax: 410-761-5127
Email:
|
www.GlueMachinery.com
6
Champ3
TM
Caution:
-
Do not lay gun on its side.
- Never overfill gun, Fill to 3/4 full.(this is below tank lid/cap when inserted into tank)
- Press trigger only when gun is heated to the recommended adhesive application temperature
And the glue at the bottom of the tank is molten and at the desired viscosity.
- Before changing the glue type, purge all glue from gun.
- Do not point glue nozzle towards people.
- Do not apply hot melt upward to an overhead substrate.
- Do not hold nozzle tip upward.
- Never work without having installed a nozzle.
- Stop using the gun, if casing is damaged due to shock, breakage or heavy wear.
- Do not use gun if adhesive is leaking from nozzle or any other portion of the gun.
- If hot melt has migrated through cap vent hole into cap, the cap must be cleaned.
- Vent hole in cap must be clean and free of hot melt.
*Operating a gun with internal leakage is dangerous to the operator and makes repairs of the gun
extremely difficult.
Caution: Hot Surface!