CHAMP
3
TM
H
OT
M
ELT
G
LUE
G
UN
P
ART
#
C
HAMP
3
Glue Machinery Corporation
™
4234 Boston St, Baltimore, Maryland 21224
Toll Free 1-888-202-2468 | Phone: 410-761-2727 | Fax: 410-761-5127
Email:
|
www.GlueMachinery.com
17
Champ3
TM
14)
The vent hole in the bottom of the tank lid must be clear for proper operation. If this hole is clogged it
will create a vacuum in the gun that will impair performance.
15)
Keep hot melt free of dirt and humidity.
16)
Do not start gluing before glue is molten and fluid in the gun.
17)
Hot Melts that have not become completely molten are not at the correct gluing temperature required.
18)
Hot Melts below the optimal gluing temperature will not produce optimal gluing results.
19)
Higher viscosity hot melts will require additional trigger pressure.
20)
Excessive manual trigger pressure can accelerate the wear of internal components.
21)
Frequency of filling the tank with hot melt chips, pellets or other adhesive depends on consumption rate
and adhesive.(Do not overfill tank)
22)
Adding hot melt to a tank that is partially filled with molten adhesive will increase melt rate.
23)
Adding pellets, pillows or chips of adhesive to the tank with a small amount of molten adhesive in the
tank will raise the viscosity of the molten adhesive in the tank and can affect gun and adhesive
performance.
24)
Only start using the tool when the glue has become molten. Test pattern capability and familiarize
yourself with the tool prior to use.
25)
Never invert/turn the tool upside down.
26)
When done using tool, unplug from power source.
27)
Gun and Glue remain hot for up to 1 hour after unplugging.
28)
Tool does not need to be purged of glue at shut down. Never lay gun on its side.
Caution: Hot Surface!
Warning:
Once the gun has warmed up, nozzle and cover are extremely hot!
Warning:
Never use tool without wearing protective gloves and safety glasses.
