GLP impression FR1O BAR, Quick Start And Safety Manual

Page: 13 / 28

German Light Products®
Impression FR10 Bar Quick Start and Safety Manual Rev. A
13
5. Installation
Warning! Read ‘Safety’ starting on page 4 for important safety information
that you must understand before you install or operate the fixture. Install FR
10 Bar fixtures only as described in this chapter, or you may create an
installation that is unsafe.
It is the installer’s responsibility to provide a stable, secure supporting
structure that is suitable for the environment and application and that
meets all applicable codes and legal requirements. Note the requirement
to secure lighting fixtures with safety cables in temporary installations.
Mounting options
An FR 10 Bar fixture may be installed in one of the following ways:
Standing horizontally on a horizontal surface.
Fastened to a rigging truss or similar structure at any angle using the supplied
brackets and two or more rigging clamps (optional accessories).
Securing the fixture with a safety cable
If a fixture can cause injury or damage if it falls you must secure it with at least one
secondary attachment such as a safety cable that will hold it if the primary means of
attachment fails. The safety cable must be approved for the weight that it secures. In
multiple installations, each fixture must have its own safety cable.
To secure an FR 10 Bar fixture with a safety cable:
Obtain a safety cable that is approved for the weight of the fixture and rigging
hardware that it will secure.
Figure 4. Safety cable attachment points