5
2000225013B
CL
FLUE
CL
BOILER
1 General Information
Diagram 1.1
INSIDE WALL
FIXING FACE
10156
15
140
18
22
122
156
134
SAFETY
DISCHARGE
DRAIN
GAS
450
176
715
145
IMPORTANT NOTICE
The boiler is supplied in one pack, the flue and fixing jig are
supplied seperately.
This boiler is for use only on G20 natural gas.
Where no British Standards exists, materials and equipment
should be fit for their purpase and of suitable quality and
workmanship.
Refer to Manual Handling Operations, 1992 Regulations.
The installation of this boiler must be carried out by a competent
person in accordance with the rules in force in the countries of
destination.
Manufacturer’s instructions must not be taken as overriding
statutory requirements.
1.1 Sheet Metal Parts
WARNING:
When installing the appliance, care should be
taken to avoid any possibility of personal injury when handling
sheet metal parts.
1.2 Statutory Requirements
The installation of the boiler MUST be carried out by a competent
person in accordance with the relevant requirements of the
current issue of:
Manufacturer’s instructions, supplied.
The Gas Safety (Installation and Use) Regulations, The Building
Regulations, The Building Standards (Scotland) Regulations
(applicable in Scotland), local Water Company Bylaws, The
Health and Safety at Work Act, Control of Substances Hazardous
to Health, The Electricity at Work Regulations and any applicable
local regulations.
Detailed recommendations are contained in the current issue of
the following British Standards and Codes of Practice, BS4814,
BS5440 Part 1 and 2, BS5449, BS5546, BS6700, BS6798,
BS6891 and BS7074 Part 1 and 2, BS7478, BS7593, BS7671.
We also suggest that you have to hand a copy of the British Gas
publication, “Guidance Notes for the Installation of Domestic
Condensing Boilers”.
Manufacturer’s notes must not be taken as overriding statutory
obligations.
BSI Certification
This boiler certificated to the current issue of EN 483 for
performance and safety.
It is important that no alteration is made to the boiler, without
permission, in writing, from Hepworth Heating Ltd.
Any alteration that is not approved by Hepworth Heating Ltd.,
could invalidate the warranty and could also infringe the current
issue of the Statutory Requirements.
77
