206M 201805
9
13. Trouble shooting table:
14. Guide for ordering spare parts
1. Firstly, the damaged or ordered sample should be gained and confirmed the quantity of spare parts
2. Confirm the replaced parts specification, avoid wrong order.
The confirmed method showed as following:
According to the use range and place position of parts, find out the codes of parts in the exploded drawing (section 17) from
the manual.
For example, if lifting level is needed to be ordered, resulting from the fact that lifting level always placed in the sleeve, and
its exploded drawing position is showed as below:
Problem Reason Solution
The turntable rotates just in one
direction or can’t rotate.
Reverse Switch broken
Replace the Reverse Switch
Belt broken
Replace the belt
The Motor’s malfunction
Check the motor cable or terminal
block wire;
Replace the motor if it was broken.
Demount or fix the wheel, the
turntable can’t lock (spin with
wheel);
The jaws delay to open/close;
The turntable locks the rim
incorrectly.
Leakage of Air network
Check all the parts on the air
network.
The clamping cylinder can’t work.
Replace the cylinder piston.
Worn jaws
Replace the jaws.
Broken washers of the chuck
cylinder
Replace it.
The mounting/demounting head
always touch the rim during
operation.
The locking plate incorrectly adjust
or unqualified.
Replace or adjust it.
Screws on the chuck loose; the
Hexagonal Vertical Arm can’t be
locked by Locking Plate
Tighten the screws; replace the
Locking Plate.
The Bead Breaker Pedal and Jaw
open and close Pedal can’t turn
back to the original position.
pedal spring broken
Replace it.
The Bead Breaker shovel operates
difficultly.
Jammed silencer
Clean it or replace it.
The washer on the Bead Breaker
cylinder is broken.
Replace it.