Glomex pandora v8000, User Manual

Page: 68 / 172

PANDORA V8000 - URANIA 2 V9330
66
ENGLISH
www.glomex.it
5. Intermittent images for short
periods
- the satellite signals are
obstructed by masts of other
boats, bridges, on-board
equipment, etc.
- move the boat to allow an
unobstructed view for the
antenna
- the boat is at the boundary of
the coverage area
- bad weather conditions
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
59 in this manual
- wrong SKEW adjustment - adjust the SKEW by following
the instructions on page 53
6. The equipment does not find
the satellite (the led on the
control unit is red)
- the satellite signals are
obstructed by masts of other
boats, bridges, on-board
equipment, etc.
- move the boat to allow an
unobstructed view for the
antenna or correctly position
the antenna on the boat
- the boat is outside the signal
coverage area
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
59 in this manual
- the boat is heaving within the
first 60 seconds after turning
on the equipment
- bad weather conditions
- turn off the equipment for 10
seconds, turn it on again and
make sure that the boat is still
or moves in a straight line
during the first 60 seconds
after being turned on
- inner failure - contact the Service Centre
- wrong SKEW adjustment - adjust the SKEW by following
the instructions on page 53
7. The equipment does not find
the satellite (the led on the
control unit flashes alternately
red and orange)
- the satellite signals are
obstructed by masts of other
boats, bridges, on-board
equipment, etc.
- move the boat to allow an
unobstructed view for the
antenna
- the equipment software is not
up to date
- please contact the Service
Centre to ask for the software
update by SD card
- wrong SKEW adjustment - adjust the SKEW by following
the instructions on page 53
8. Disturbed images - failure of the receiver - refer to the user manual of the
receiver for support, spare
parts and warranty conditions.
9. Confused, incomplete and
obstructed images
- condensate or rain on the
radome, which can disturb the
signal
- remove the condensate deposits
from the radome with a fresh
water jet (not under pressure)
- bad weather conditions - periodically apply a liquid
detergent suitable for dishes
(no alcohol-based detergent)
to the radome surface and let
dry up
- wrong SKEW adjustment - adjust the SKEW by following
the instructions on page 53