Glomex pandora v8000, User Manual

Page: 51 / 172

PANDORA V8000 - URANIA 2 V9330
49
E
N
GL
IS
H
www.glomex.it
12. To connect the coaxial cable it is necessary to
remove the upper radome and to connect it to
the connector (1) found on the lower radome,
trying to give it a path that follows the curvature
of the radome.
13. Make sure that the cable core is correctly
inserted in the central hole of the female
connector on the antenna (otherwise, there
could be a short circuit and the fuse installed on
the power supply line inside the control unit
would trip).
Manually screw in the ring nut of connector F.
Once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench.
14. Remove the two safety straps found on the
azimuth and lifting gears.
S
WARNING
For a correct assembly, respect the installation
direction indicated in
Fig. 10 .
A different installation from the recommended one
could cause an incorrect operation of the antenna
due to the risk of water penetration into the
radome.
Operations to be carried out inside the boat.
1. Determine the correct position for the control
unit:
- it must be positioned near the satellite
receiver, as the provided coaxial cables are
1.5 m long;
- it must be reached by the power supply
cables coming from the control panel;
- it must be reached by the coaxial cable
coming from the antenna (10 m long);
- it must be positioned in a dry and ventilated
area.
2. Connect the coaxial cable of the antenna
(previously installed) to the ANTENNA IN input
on the control unit and one of the 1.5 m coaxial
cables to the RECEIVER OUT output on the
control unit.
Make sure that the cable cores are correctly
inserted in the central holes of the relevant
female connectors on the control unit
(otherwise, there would be a short circuit and
the fuse installed on the power supply line
inside the control unit would trip).
Manually screw in the ring nuts of connectors F.
Once the ring nuts have been manually
screwed in, tighten by ¼ turn by means of a 11
mm wrench.
S
WARNING
The inversion of the two cables jeopardizes the
operation of the equipment. Make sure you have
correctly installed the coaxial cables. In case of
damage, GLOMEX will not be directly liable for the
damage suffered by the receiver.
Fig. 16
Fig. 17
Central coaxial cable
conductor
From the
antenna
To the V9115 line
amplifier
Fig. 18
Power supply
cable
Red
Black