Glomex pandora v8000, User Manual

Page: 63 / 172

PANDORA V8000 - URANIA 2 V9330
61
E
N
GL
IS
H
www.glomex.it
9. MAINTENANCE
9.1 PREVENTIVE MAINTENANCE
GLOMEX antennas PANDORA V8000 and
URANIA 2 V9330 require minimum preventive
maintenance.
Observing the following instructions is sufficient to
maintain a high equipment performance.
Monthly checks
- Wash the radome surface with a cloth damped
with fresh water; do not direct pressurized water
jets onto the radome.
S
WARNING
Do not use brushes, abrasive products, detergents
or alcohol-based liquids.
Yearly checks
- Check the outer conditions of the radome. Clean
from dust and dirt if necessary.
Checks before any long cruise
- Check that the antenna is correctly fastened.
S
DANGER
Before carrying out any maintenance or cleaning
operation, or after each use, ALWAYS turn off the
antenna by means of the switch located on the
control unit or from the on-board control panel.
9.2 SPARE PARTS
Should you have problems with the operation or in
case you need technical support, first of all contact
the authorized Retailer. Keep at hand the serial
number of your antenna (on page 2 in this manual)
and a list with the failure symptoms. Should no
Retailer be available, contact the GLOMEX Service
Centre (see section “Technical Support”).
S
WARNING
You will be asked the serial number of your
antenna during any service or troubleshooting
phone call. The serial number is found on page 2 of
the user manual of your antenna (see page 39 for
serial number indications).
S
WARNING
Conserve the installation and user manual with
care, as it contains the serial number of your
antenna!
The following table lists the codes of the
components which can be supplied as spare parts
directly by the Retailer.
Component GLOMEX code
Lower radome V8000 4.010.0143
Upper radome V8000 4.010.0410
Lower radome V9330 4.010.0413
Upper radome V9330 4.010.0414
Fuse for control unit T3A15 5x20 4.120.0076