Page 8
Operating Instructions
2. To rotate bowl guard to its open position, grasp the separated handles on the bowl guard and move them,
together as one, clockwise to open/rotate bowl guard. To close bowl guard, grasp the separated
handles and move them together as one, counterclockwise to close/rotate bowl guard back into a locked
position.
Removing and Attaching Bowl Guard:
NOTE:
Before removing or attaching the bowl guard, make sure the bowl is in the down/
lowered position and the agitator tool is off the shaft.
1. To remove bowl guard for cleaning, push the lower part of the separated handle
out (clockwise) dividing the handle and releasing the guard from the rotation ring
(Fig. 8-1).
2. Once separated, take hold of the lower separated handle and continue turning the
guard clockwise until the bowl guard releases from the ring catch (Fig. 8-2).
3. To reattach bowl guard, line up ring catch on the left of mixer; lift
guard gently into place and rotate the guard’s lower handle counterclockwise
until it snaps back into place with the upper part of handle.
ATTACHING BOWL TO MIXER
NOTE:
Install bowl BEFORE attaching agitator.
1. Lower bowl by pulling bowl lift lever forward and down to its resting
position. For models SPC40 and SPC60 rotate bowl lift wheel
counterclockwise until it stops. For the SPC62P and SPC80PL press the down
arrow (blue button) to lower bowl until it stops.
2. Lift bowl by bowl handles and:
a. Slowly position locking pin (located on the rear of bowl) into the hole in the
middle rear of cradle (Fig. 8-3).
b. Lower bowl onto pins located on either side of bowl cradle.
3. Once bowl is positioned on the cradle, secure bowl by pulling each bowl clamp
forward until bowl is locked tight (Fig. 8-4).
Fig. 8-1
Fig. 8-2
Fig. 8-3
Fig. 8-4
Summary of Contents for SPC10
Page 2: ......
