Page 11
Operating Instructions
Before starting mixer:
Always change speeds BEFORE starting the Mixer. Failure to do
so can damage the gears or other parts and WILL void the warranty!
USING MIXER’S DIGITAL CONTROLS AND TIMER
Read through this section and continue to page 13 for further operating instructions for use of the digital
controls on your mixer.
Mixer is equipped with a digital timer display, minutes and seconds buttons (to adjust the timed operations) and
Start / Stop buttons. Mixer can function in either timed operation or untimed operation.
Untimed Operation:
For simple on/off mixing operation in an untimed operating mode, verify that bowl guard and
bowl lift are closed and locked into position.
- The display should read 00:00 to operate in untimed mode. Pressing the STOP button twice within one
second will reset the timer back to zero.
- Press the START button to begin mixing. The display will scroll zeros from left to right while mixing. Press the
STOP button when the desired mixing is complete.
NOTE:
Pressing STOP button twice within one second to reset the timer back to zero (00.00) is a feature only
available for models SP10-SP60.
Timed Operation:
The timer on the mixer can be set from 5 seconds to 60 minutes.
1. Set desired time. Minutes advance by one and seconds advance by fives before rolling over to zero.
NOTE:
Press and continuously hold the up arrow button to the desired minutes and seconds. Press and
continuously hold as the button scrolls through the number cycles quickly. (To slow down the selection and to
better control the setting time, press the up or down arrow button (Do NOT continuously hold the button down).
2. Once the desired time is set, make sure that the bowl guard and bowl lift are closed and locked into
position and then press START.
3. Wait for the timed cycle to end or press STOP to pause mixing cycle.
- Pressing the STOP button once stops mixer and pauses the timer during operation.
- Pressing the STOP button once while mixer is not in operation will reset the timer to the
last programed/set time.
- Double clicking the STOP button twice within one second while the mixer is not in operation
will reset the timer back to zero (00:00).
NOTE:
Pressing STOP button twice within one second to reset the timer back to zero (00.00) is a feature only
available for models SP10-SP60.
NOTE:
If a cycle is interrupted by the bowl guard being opened or by lowering the bowl lift lever, the mixer will
stop. After the bowl guard and bowl lift are closed and locked into postion, The START button can be pressed to
continue the programmed/set time.
To add additional minutes or seconds to a mix time, STOP the mixer, and adjust the cycle mixing time.
4. Once a timed cycle ends, the mixer will beep for 5 seconds and the digital display will flash for two
minutes (if not reset) indicating the timed cycle is complete.
Summary of Contents for SPC10
Page 2: ......
