Page 6
Installation
UNPACKING
Unpack the mixer immediately after receipt. If the machine is found to be damaged, save the packaging material
and contact the carrier within fifteen (15) days of delivery. Immediately contact your source of the equipment.
You have no recourse for damage after fifteen (15) days.
TO AVOID SERIOUS PERSONAL INJURY:
•
ALWAYS
install equipment in work area with adequate light and space.
•
ONLY
operate mixer on a solid,
LEVEL
, non-skid surface that is nonflammable.
•
NEVER
bypass, alter, or modify this equipment in any way from its original condition. Doing so can create
hazards and will void the warranty.
•
NEVER
operate mixer without all warnings attached.
•
DO NOT
attempt to lift mixer alone.
INSTALLATION
1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation and
operation if you have any questions or do not understand everything in this manual. Contact your local
representative or Globe first.
2. Remove the corrugated box from the skid by removing the bands on the box.
NOTE:
The SPC62P and SPC80PL are shipped in a wooden crate; only the bolts at the bottom of the crate
(all four sides) need to be removed.
3. Carefully unbolt mixer from the skid using an 11/16'' or 3/4'' wrench.
4. Select a location for mixer keeping these points in mind:
• Floor or counter must be level.
• Easy access for maintenance and service.
• Clearance for operating controls, installing and removing agitators, bowl, or attachments.
• Sufficient space for adding ingredients during mixing periods.
• Make sure rear ventilation outlet of mixer is not blocked.
5. Use at least two other people to tilt the unit and install the rubber feet.
6. A bolt down template and bolts are available for the SPC10, SPC20, or SPC25. Contact Globe if needed.
7. Inspect mixer to make sure all parts have been provided (i.e. bowl, beater, whip and dough hook). The
SPC60, SPC62P and SPC80PL only have a bowl, dough hook and bowl truck.
8. Read the electrical information found on the data plate located at the rear of the machine. The incoming
power must match the rating on the data plate.
CONNECTING TO ELECTRICAL POWER
Cord Connected Units: This machine is provided with a three-prong grounding plug. The outlet that
this plug is connected to must be properly grounded. If the receptacle is not the proper grounding type,
contact an electrician. Do not under any circumstances cut or remove the third ground prong from the
power cord or use an adapter plug. Never use an extension cord. Low power supply could damage the
mixer and/or cause a fire.
Summary of Contents for SPC10
Page 2: ......
