Page 17
Front Mounted Knife Sharpener
Figure 17-1
Figure 17-2
Figure 17-3
SHARPENING THE KNIFE
Note: Sharpening and honing stones will perform correctly ONLY when free from dirt, grease and built-up food
residue. Use the wire brush included with your slicer to periodically clean the stones BEFORE
sharpening the knife blade.
1. Plug in power cord.
Note: The white POWER indicator light will illuminate.
2. Push the START button to turn on knife motor.
Note: The green RUN indicator light will illuminate.
3. Push down and turn sharpening knob counterclockwise to #1. Release sharpening knob (Figure 17-1).
4. Sharpen knife blade for 30 seconds.
Note: SG13 & SG13A models. The slicer is equipped with a motion timer feature, make sure that the motion
timer is set to 30 seconds. Refer to Maintenance Mode section of the Owner’s Manual supplied with the
machine.
5. Push the STOP button to turn knife motor off.
Note: The green RUN indicator light will go out.
6. Push down and turn sharpening knob clockwise to #0. Release sharpening knob (Figure 17-2).
7. Push the START button to turn on knife motor.
Note: The green RUN indicator light will illuminate.
8. Push down and turn sharpening knob clockwise to #2. Release sharpening knob (Figure 17-3).
9. Hone the knife blade for 15 seconds.
AFTER SHARPENING
1. Push the STOP button to turn off the knife motor.
Note: The green RUN indicator light will go out.
2. Push down and turn sharpening knob clockwise to #0.
3. Unplug the power cord.
Note: The white POWER indicator light will go out.
4. Turn the locking knob assembly counterclockwise to loosen front mounted sharpener from the slicer table (Figure 17-4).
BE ALERT. The next step will expose knife.
5. Lift up on the front mounted sharpener to remove from gap.
6. Hold the front mounted sharpener and the carriage handle to move the front mounted sharpener and carriage to the home
postion.
7. Remove the front mounted sharpener from the slicer table.
8. Turn the slice thickness dial past the 0 mark until the table is fully closed and the slice thickness dial stops moving.
9. Clean and Sanitize the entire slicer. Refer to Cleaning & Sanitizing secion of the Owner’s Manual supplied with the machine.
10. Plug in power cord.
Note: The white POWER indicator light will illuminate.
Figure 17-4