Globaljig SYSTEM, User Manual

Page: 16 / 28

USER’S MANUAL
SYSTEM/VECTOR
CHAPTER 8
8. OPERATIONS
8.1. WARNINGS
Once the installation (see Chap. 05) and start-up (see Chap. 06) procedures
have been completed, the Vector is ready. It does not require any specific
calibration.
However, remember, no equipment is risk-free during operations. Therefore,
always apply the following precautions:
⇒ Before using the Vector check that all bolts securing it to the Bench and
securing the half rings are fully tightened.
⇒ Check that the engage/release lever is in the horizontal position
(locked).
⇒ Check that the chain, running from the Hook Connection, is fully
aligned and there are no loops .
⇒ Make certain that the pulley pins and hydraulic cylinder connections are
fully secured with the supplied Safety rings.
8.2. OPERATIONS
Starting conditions: vehicle to be repaired secured to the Bench following
the indications in the GLOBALJIG data sheet.
• Determine what part of the body needs to be straightened.
• Position the Vector on the SYSTEM Bench following the instructions in
Chapter 06. Then arrange it to achieve the correct pulling direction by
correctly positioning the snub pulley–chain on the axial wheels of the
vertical arm and on the radial rotation of the horizontal body.
• Body side: connect the chain Hook to the terminal secured to the body
sheet.
• Vector side: pull and stretch the chain until the free end of the chain
engages the arranged hooking site.
• Start up the manual or pneumatic pump that drives the hydraulic cylinder
so the Vector can apply the pulling force.