![background image](http://html.mh-extra.com/html/global/foli-mechanism-with-ecs/foli-mechanism-with-ecs_user-manual_2232462009.webp)
PHATB460 HANDSET DISPLAY INSTRUCTIONS
Settings
By pressing
Up and
Down buttons simultaneously you
enter the Settings menu.
You are now able to step between the Settings menu with the
Up and
Down button.
To exit the menu, just step all the way down by pressing the
Down button a number of steps.
The Settings menu have the following steps in this order:
Err
ECS
SOF
rES
SL
SU
CAL
Un – Settings menu entry level
Exit
To enter a menu, press
Up and
Down button
simultaneously.
To adjust value, press
Up or
Down button.
To save and/or exit setting, press
Up and
Down buttons simultaneously.
Mount the Handset
Use the 2 attached screws for fixing to the table top. If the
thickness of the table top is less than 3/4 inch (18mm) please
use shorter screws.
Start Up
Initial display communication “view.” Under normal condition the
display automatically shows the layout as below in 2 to 5 sec.
If the system is in reset mode the reset icon will be visible.
In that case, press the Down button until the symbol goes away.
ECS
ECS for ECS Software, will show the software version of the
ECS box. Version is shown as Year and Week. Y.W.
Press
Up and
Down buttons simultaneously to enter
the Settings menu. Press Up button until you reach ECS.
To enter, press
Up and
Down buttons simultaneously.
The version of the software is now shown on the display.
To exit setting, press
Up and
Down buttons
simultaneously.
Connect the handset
Connect the cable to the ECS+ box.
Error Codes
1.
Hard stop
2.
Back off
3.
Soft stop
4.
Waiting for button
5.
Waiting for button release
6.
Motor lost
7. Overcurrent
8.
Overheating. Thermometer flashing, wait 10 minutes
for motor cooling
9.
Low voltage (under 16vdc)
10.
High Voltage (over 40vdc)
11.
Motors far apart /sync error
12.
Destination above upper limit
13.
Destination below lower limit
14.
Internal error
15.
Collision detected by sensor
This manual is a quick guide of the functionality for the PHATB460 Handset Display.
This handset is intended to be used with ECS+ control box only, included with the PHATB460.
Default error
code example
Error code 8,
flashing thermometer
Handset
9