![background image](http://html.mh-extra.com/html/global/318513/318513_operation-manual_2232495016.webp)
318513
www.globalindustrial.com
.
13
(4). Command: T<CR> (54h 0dh)
Response: <LF> H1H2H3<CR><ETX>
TARE function is activated, and then returns scale status, similar to pressing the
TARE key. If TARE function cannot be activated, it will return to current scale
status.
(5). Command: U<CR> (55h 0dh)
Response: <LF>u1u2<CR><LF> H1H2H3<CR><ETX>
Changes units of measure and return scale status with new units, similar to
pressing the UNIT key. The new measure unit should be allowed to use as a C5
setting. If the weight unit is lb:oz, U1U2= “lb oz”
(6). Command: L<CR> (4ch 0dh)
Response: <LF> H1H2H3<CR><ETX>
If HOLD function is enabled, go to or exit from HOLD mode, similar to pressing
the HOLD key.
(7). Command: X<CR> (58h 0dh)
Response: NONE
Power off the scale, similar to pressing and holding the ZERO/ON/OFF key for 4
seconds.
(8). Command: all others
Response: <LF>? <CR><ETX>
Unrecognized command
e) Additional Commands and Responses for Scale Base Application:
(1). Command: F<CR> (46h 0dh) --- to restore factory calibration data
Response: <LF>OK H1H2H3<CR><ETX>
(2). Command: O<CR> (4Fh 0dh) --- zero point calibration
Response: <LF>OK H1H2H3<CR><ETX> --- if zero calibration is sufficient
<LF> H1H2H3<CR><ETX> ---- if zero calibration resulted in an error
(3). Command: H<CR> (48h 0dh) --- weight calibration
Response: <LF>OK H1H2H3<CR><ETX> --- if weight calibration is sufficient
<LF> H1H2H3<CR><ETX> --- if weight calibration resulted in an error
f) Output status bit meaning:
The status bit definition:
Bit
Byte 1 (H1)
Byte 2 (H2)
Byte 3 (H3)
0
0=stable
0= not under
capacity
01=normal work
mode
10= hold work mode
00=not define
11= not define
1= not stable
1= under capacity
1
0= not at zero
point
0= not over
capacity
1= at zero point 1= over capacity
2
0=not AD over
0=not Zero Over
0= gross weight
1=AD over
1=Zero Over
1= net weight