WARNING:
The heater must be installed on the solid surfaces like concrete, wood or metal, etc.
WARNING:
Ensure that the supply cable is well mounted and does not come into contact with
reflector of the heater or that does not trail into heated area. The supply cable can be fixed to the
metal mounting bracket behind heater with plastic zip ties.
Heater to be installed by a qualified installer.
ALWAYS disconnect the heater and allow it to cool before installation/or maintenance.
For ceiling mounting, the lowest part of the heater must be located at or above a minimum height
of 7.8-ft. from the floor.
Allow a minimum of 20” from each side of the heater to the wall
The distance from the front side of the heater to materials such as wood, carton, cloth etc., must
be a minimum of 3.5-ft.
For ceiling mounting, DO NOT position the heater at an angle more than 90° or less than 45°.
The supply cable must be at the lower end of the heater if the heater is installed at an angle or
vertically.
Keep the supply cord away from the body of the heater which will get hot during use.
DO NOT install the heater on an inflammable surface.
Observe the minimum safe distance between the heater body and the inflammable surfaces
when mounted.
The heater must be installed on the mounting brackets provided.
Fasten the brackets securely to the mounting surface and the backside of the heater using the
nuts and screws provided.
The brackets can be used to adjust the direction of the heater, adjust the heater angle by
loosening the two bolts on the wall mounting bracket, tighten the bolts again when the desired
angle is reached.
Hardware Included:
Ref.
Type
Size
Qty.
1
Bracket
L-Shaped
4
2
Plastic Anchor
5/16” x 1-1/4”
4
3
Screw
3/16” x 1”
4
4
Nut
1/4”
2
5
Screw
1/4” x 1/2”
2
Wall Mounted Installation:
