![background image](http://html.mh-extra.com/html/global/244280/244280_user-manual_2232494016.webp)
244280
www.globalindustrial.com
13
7. Display A/D code and working voltage
7.1 In normal working mode, press and hold
ESC/ON/OFF
and
3
key until scale displays
“CODE”, then displays inner code (if inner code is bigger than 999999, it will display on
two pages H xxxx and L xxxx). Press
Unit
key to display H xxxx, L xxxx or display both
automatically.
7.2 Press TARE key to tare the inner code
and display net inner code, “NET” symbol will be
on. Press TARE key again to display the inner code and “NET” symbol will be off.
7.3 Press
FUNC.
key to check the working voltage, shows “U.x.x” (Voltage x.x V), this
means the inner working voltage is x.x V. If the scale uses an AC power adaptor, the
voltage is the power adaptor voltage after regulating. If an AC adaptor is not used, the
voltage is battery’s voltage.
8. Display symbol meaning
Err01
:
weight is too big
Err04
:
exceed zero range
Err05
:
less than zero range
Err12
:
parameter is not correctly set
Err20
:
calibration error
Err30
:
inner code is too big
CAP.
:
capacity
UOL.:
voltage
UNIT:
measuring units
UnLoAd
:
no loading
LoAd
:
load weight
INP.Ld
:
input loaded weight value
9. Troubleshooting
9.1 Battery and Charging
Power is supplied by an internal rechargeable NI-MH battery
. When “
Lo.bAt
” is displayed,
the battery must be recharged. Plug in the AC power adapter to recharge the battery. The
scale may continue to be used on AC power during charging. Full charging time is
approximately 10-12 hours.
Battery life and recharge time will vary with use. Over time, the operating time per each full
charge will degrade. If the operating time is no longer acceptable, the battery must be
replaced. When storing the scale for extended periods, the battery must be charged every
180 days to avoid premature performance degradation. For replacement information,
contact Global Industrial at 1-800-645-2986.