Global Power Technologies
1120 - Class I, Division 2, Group D, T3
2 .2 Start-Up Data Sheets
Start-up Data Sheets are provided at the back of this manual to assist you in setting up the
TEG properly. During set up you will be asked to record data on these sheets so keep them
available. It is recommended that a Data Sheet be used each time the TEG is started. They
are valuable for future reference. If additional sheets are needed they can be duplicated.
2 .3 Starting Generator
Perform the following steps (see Figure 10):
2.3.1 Turn on fuel. Loosen the lock nut on the fuel regulator.
2.3.2 If required, correct the factory set fuel pressure for the elevation as per Figure 9,
Change
in Fuel Pressure Vs . Elevation .
2.3.3 Adjust the air shutters to slightly fuel rich from the factory set position. Note that the air
shutters should always be adjusted equally in small increments.
2.3.4 Set the “Power Switch” to set up position.
2.3.5 Set the “Output Voltage Adjust” to middle position.
Figure 10
TEG Start Up
17