CHAPTER 6 – SERVICE
Monitor Service
At some point it may be necessary to remove the monitor from the cabinet for service or replacement. Please
follow the instructions below, and follow all safety standards while working with a monitor. When removing
the monitor from the cabinet it is always best to have 2 people support the weight of the monitor.
Figure 49
– Cable Connections to the Monitor Chassis
To remove the monitor, begin by unplugging the cables from the Monitor chassis. You will need to remove 3
cables from the chassis, and make sure there are no wire ties holding these cables to the monitor frame. See
the figure above.
1. Remove the VGA Video cable from the back of the Monitor
2. Remove the Monitor Control Panel cable located near the center of the chassis. The cable is a 5 wire black
cable.
3. Remove the Power Cable located on the left hand side of the chassis closest to you as you face the monitor
from the back of the cabinet.
Next remove the (3x) T-25H Security Torx screws holding the Driving Control Panel assembly and lower the
assembly down. At the top of the cabinet fold the Marquee forward and remove the two Phillips screws
holding the top of the monitor cover to the cabinet. See the following figure:
Figure 50
– Releasing the Driving Control Panel and Marquee
44
GLOBAL
VR
040-1201-01 Rev. C 5/28/2004
