4
globalspecialties.com
Global Specialties
Hands, shoes, floor, and work bench must be dry. Avoid making
measurements with dampness, or other environmental conditions that might
affect safety.
General Safety Information
To avoid personal injury and/or product damage, review and comply with the following safety
precautions. These precautions apply to both operating and maintenance personnel and must
be followed during all phases of operation, service, and repair o this meter. Before applying
power be sure to:
•
Read and understand the safety and operational information in this manual.
•
Apply all the listed safety precautions.
•
Verify that the voltage selector on the back of the unit is set to the correct line voltage.
Operating the instrument at an incorrect line voltage will void the warranty.
•
Make all connections before applying power.
•
Do not operate the instrument in ways not specified by this manual or by Global
Specialties.
Failure to comply with these precautions or with warnings elsewhere in this manual violates
the safety standards of design, manufacture, and intended use of the instrument. Global
Specialties assumes no liability for a customer’s failure to comply with these requirements.
Dry Conditions
Use a soft cotton cloth lightly moistened with a mild solution of detergent and
water. Do not allow any portion to be submerged at any time. Dry thoroughly
before attempting to make measurements. Do not use solvents or expose to
solvent fumes as they may cause deterioration or damage.
Cleaning
Do not Operate
•
In the presence of noxious, corrosive, flammable fumes, gases, vapors, chemicals, or
finely-divided particulates.
•
In environments where there is a danger of any liquid being spilled on the meter.
•
In air temperatures exceeding the specified operating temperatures.
•
In atmospheric pressures outside the specified altitude limits or where the
surrounding gas is not air.
Only for use in pollution degree 2 environments where non-conductive pollution occurs except
occasionally when a temporary conductivity caused by condensation is expected.
CAUTION
WARNING
