Global Coolers TOUCHLESS TL-1, Manual, Page: 7 / 16

Installation
1. Remove drip tray from door and place the grid on top.
2. Snap drip tray and grid assembly into door.
3. Open dispenser door.
4. Place probe assembly on probe hanger.
5. Place the new bottle outside of cabinet.
6. Remove the plastic cap from top of bottle.
7. Clean outside of new bottle with a clean cloth.
8. Place probe into bottle.
9. Slide collar down until it clicks in place.
10. Push head down until pipes hit bottom of bottle.
11. Slide bottle into cabinet and close door.
12. Plug cord into a properly grounded wall outlet. The pump will begin to move water from the bottle
to the hot and cold tanks. It will take up to 12 minutes to fill the tanks for the first time. During this
period the pump will run continuously.
13. Turn on switches to start heating and cooling water. If you do not want to heat water, turn of the
red switch. If you do not want to cool water, turn off the green switch in.
14. To secure the dispenser to the ground, loosen the screw on one of the lower corners of the unit.
15. Use the screw to secure the bracket to the appliance.
16. Make a hole in the ground where the dispenser is to be installed.
17. Secure the bracket to the floor by screwing firmly.
ATTENTION : This unit will not dispense hot or cold water until the switches are activated.
Before we start :
- Place dispenser upright.
- Locate dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet.
Do not plug the power cord yet.
- Position dispenser so the back is at least 10cm from wall and there are at least 10cm of clearance
on both sides.
- This unit has been tested and sanitized prior to packing and shipping. During transit dust and odors
can accumulate in the tank and lines. Dispense some water before drinking any.
Installation and starting up
7