Global Contract Licence 2, Installation Manual

Page: 45 / 100

•Page globalcontract.com 44
GLOBAL
Contract
• Fall 2017
INSTALLATION GUIDELINES
L2Bxxxx
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed are to assemble desk. It is advisable to do fi nal
assembly upside down.
STEP 3: Modesty panel. Install Blum Connecter screws in pre-drilled holes on top
edge of the Modesty.
STEP 4: With the worksurface laying upside down on the fl oor, Pick up modesty
lining up Blum connecter screws to the Blum connectors installed on the bottom of
the surface. Tighten Blum connecter ¼ turn, do not over tighten.
STEP 5: Stand completed assembly upright and you are ready to install.
STEP 6: This unit is intended to be attached to adjoining assembled units on both
ends the provided Flat Brackets. The Flat Brackets are screwed into ganged assem-
blies at the worksurface joint using #8 x ¾ wood screws.
Safety Glasses Rubber Mallet
Required Tools
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Screwdriver #2 Phillips
Wood Screw #8 3/4
L007250032
Included Hardware
Screwdriver #2 Roberson
3
6
5
4
Blum Connector
Screw L005650060 Flat Bracket
L005650025 Blum Connector
(installed) L005650061
FULL MODESTY
WORKSURFACE