17
There are two ways to create this correct
alignment. The
first
and easiest is to just
loosen the “Adjustment Knob” on the
TELESCOPING CLAMP and then rotate
the parts until they are correctly aligned as
in photo #28. Then simply retighten the
“Adjustment Knob.” Remember to leave
about 1 inch of TELESCOPING POST
showing
below
the
TELESCOPING
CLAMP as before.
The
second
way to correctly align the
parts (see photo #27) is to use an Allen
Wrench or Screwdiver to loosen the
“Screw” on the top part of the
TELESCOPING CLAMP until you can
rotate the parts so they are correctly
aligned as in photo #28. Then simply
retighten the screw.
NOTE
: The second method of alignment
is
better
because
it
keeps
the
TELESCOPING CLAMP’S “Adjustment
Knob” aligned correctly as previously
shown
in
photo#22.
Having
the
TELESCOPING CLAMP’S “Adjustment
Knob” aligned correctly, although not
technically
needed
to
make
your
Glidecam HD-2000 function correctly,
does make it easier to reach the Knob
later when you use it.
IMPORTANT NOTE: When using cameras that are less than one pound on the HD-1000 you will need
to increase the camera weight by adding counter balance weight plates under the camera.
27
28
