Page
25
of
34
Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot
below:
The Beatrice will have been named at the factory during test to allow them to be
identified by the Dante controller.
The format used for the factory name is:
‘BeatriceR8-snXXX’
Where ‘BeatriceR8’ refers to the Glensound product i.e. BeatriceR8.
The ‘–snXXX’ refers to the serial number of the BeatriceD8 which can be found printed
on the rear or side of the unit.
Note if you upload a new DNT file or clear the devices config then the name will change
to BeatriceD8-xxXxXx whereby the ‘X’s refer to the devices MAC address.
Dante Controller TIP
If you have never run Dante controller before then make sure that on the bottom left of
the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates that it is
connected to a network. By clicking ‘P’ or ‘S’ a pop up box opens to allow you to set
what network interface the controller is using.
Summary of Contents for Dante BEATRICE R16
Page 2: ...Page 2 of 34...