5
INSTALLATION INSTRUCTIONS
Figure 5
240/208 volt wire connections
front
front
spade E
spade G
black wire
cut and new
connection
made with wire
assembly
red wire cut and
separated with
ends capped
Figure 4
120 volt wire connections
white wire (included with heater)
GND
N
L1
red motor
wire
red motor
wire
black
motor wire
black
motor wire
white wire
white
wire
GND
L2
L1
For 240 volt installation
Connect each supply wire to one heater wire with wire connectors. For 240 or 208 volts, it doesn’t matter
which heater wire connects to each supply wire. Both supply wires (black and white) are hot. Wrap
supply (white) wire with black tape to identify it as hot.
For 120 volt installation
You’ll need the white wire assembly included with the heater. See Figure 4 for reference to wiring.
1. Attach the two yellow terminals from the white wire assembly to the heating element at spades E
and G by pushing the connectors onto the element spades.
2. Cut the black motor wire just below the crimp connector. Connect the short wire from the white wire
assembly to the black motor wire with a wire connector.
3. Cut the red motor and red element wires just below their crimp connector to separate them. Wrap
the red motor wire end with electrical tape or a wire connector.
4. Cut the white motor and black element wires just below the crimp connector. Connect the white
motor wire with the red and black element wires using a wire connector.
5. Wrap the long red lead wire with electrical tape or wire connector.
6. Connect the black lead wire to the black supply wire. Connect the remaining white assembly wire
to the white supply wire. If the heater is configured for lower voltage or wattage (see STEP 4), there
may only be a black lead wire remaining.
