Issue 5 : 01-07
Section
Page
Description
3-4
System Design
5-7
Installation
8-14
Commissioning
15
Servicing/Maintenance
15
Fault Finding
16
Parts
17
Terms & Conditions
19
These instructions should be read in conjunction with the installation/servicing
instructions issued by the manufacturer of the heat source being used.
Any installation must be in accordance with the relevant requirements of the Gas
Safety Regulations, Local Building Regulations, I.E.E. Wiring Regulations and Byelaws
of the Local Water Undertaking. It should be read in accordance with the relevant
recommendations of the following:
BS 6798; BS 5549; BS 5546;
BS 5440:1; BS 5440:2; CP 331:3
BS 6700: BS 5258 and BS 7593: 1992
It must be installed by a competent person as defined by part G3 of the Building
Regulations. Manufacturers notes must NOT be taken as over-riding statutory
obligations.
Xstream is covered by Section G3 of the Building Regulations and is therefore notifiable
to Building Control.
This information is provided to assist generally in the selection of equipment.
Responsibility for selection and specification of our equipment must however
remain that of our customer and any experts or consultants concerned with the
installation(s).
PLEASE NOTE: THAT WE DO NOT THEREFORE ACCEPT ANY RESPONSIBILITY FOR
MATTERS OF DESIGN SELECTION OR SPECIFICATION, FOR THE EFFECTIVENESS
OF AN INSTALLATION OR SYSTEM CONTAINING ONE OF OUR PRODUCTS UNLESS
SPECIFICALLY REQUESTED TO DO SO IN WRITING.
All goods are sold subject to our Conditions of Sale which are set out at the rear of this
specification. In the interest of continuously improving the Xstream range, Gledhill
Building Products Limited reserve the right to modify the product without notice, and
in these circumstances this booklet, which is accurate at the time of printing, should
be disregarded. An updated set of Instructions will be produced and supplied with
new appliances and will be made available for other appliances on request.
A KIWA PRODUCT APPROVED TO COMPLY WITH ALL RELEVANT PARTS OF THE
BUILDING REGULATIONS AND WATER SUPPLY (WATER FITTINGS) REGULATIONS.
XSTREAM IS PRODUCED UNDER AN ISO 9001:2000 QUALITY SYSTEM APPROVED BY
BSI.
As part of the undustry wide “Benchmark” Initiative all Gledhill Xstreams now include
a Benchmark Installation, Commissioning and Service Record Log Book. Please read
carefully and complete all sections relevant to the appliance installation. The details
of the Log Book will be required in the event of any warranty work being required.
There is also a section to be completed after each regular service visit. The completed
Log Book and these instructions should be left with the cylinder in the pocket
provided.
TM
benchmark
The code of practice for the installation,
commissioning & servicing of central heating systems
Page 2
