Push the Handle of the Gauge
and Lever Assembly (ITEM 24) to
its lowest position and insert the
upper end of the Control Rod
(ITEM 28) into the hole at the
rear of the Handle.
Take off one of the nuts on
the Control Rod (ITEM 28) and
insert the threaded end into
the angled bracket of the Pivot
Bracket Assembly (ITEM 19)
and affix the nut back onto the
threaded Control Rod.
Take the Rod of the Pivot
Bracket Assembly (ITEM 19) and
insert the threaded end into
the Flow Control Plate (ITEM 29)
located on the underside of the
Hopper (ITEM 25).
ITEM 30
ITEM 28
ITEM 19
ITEM 19 (ROD)
ITEM 29
ITEM 25
ITEM 19
G.
Ensure a 6mm Flat Washer (ITEM 23 - 2 off) is positioned on either side of the Flow Control
Plate and secure in position with an M6 Lock Nut (ITEM 9).
To complete the assembly, insert the R Clip (ITEM 30) into the hole in the vertical shaft of
the Gear Box and Axle Assembly (ITEM 2) from the inside of the Hopper (ITEM 25).
OPEN
CLOSED
ITEM 24
Before use, push the Lever (ITEM 24)
downwards to close the apertures in
the base of the Hopper (ITEM 25) and
pull the Lever upwards to open the
apertures.
If the apertures in the base of the
Hopper do not match the apertures in
the Flow Control Plate (ITEM 29), adjust
the position of the two nuts along the
threaded Control Rod (ITEM 28).
Once the apertures are aligned, fully
tighten both nuts.
To limit the size of the open apertures
when operating the Lever, move the
position of the Wing Nut (ITEM 24).
ITEM 25
ITEM 28
ITEM 29
H.
ITEM 24
