9 HOMEDEPOT .COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance .
ENGLISH
Topmount Installation (continued)
8
Installing the sink
NOTE: Install the faucet according to the manufacturers instructions
before completing this step . Install the vanishing edge
TM
strainer
according to the instructions before completing this step . See below .
-
Apply silicone sealant (not included) around the underside of the flange of
the sink (A) on all four sides as shown below .
- Install the topmount clips (D) into the clip channels of the sink (A) as shown
in the figures below.
- Carefully lower the sink (A) into the counter, ensuring that the topmount
clips (D) do not catch on the counter edges .
- Adjust each topmount clip (D) along the rails so that they are evenly spaced
around the sink (A) .
- Rotate the clamps of the topmount clips (D) such that they engage the
counter, and tighten the screws progressively (see tightening sequence
below) until the sink flange is flush with the counter. Check the alignment
as you tighten so that the front of the sink (A) is parallel to the front of the
counter . Adjust and re-tighten if necessary . Do not over tighten .
- Wipe away any excess sealant with a rag and allow it to set before
proceeding with the rest of the installation .
NOTE: The supply lines, which connect the faucet to the household
water system, are not supplied with this unit . They need to be
purchased separately . Follow the supply line manufacturer’s
instructions for proper installation .
9
6
2
4
3
5
1
7
8
10
Tightening sequence for clips
A
A
D
Silicone
Sealant
Clamp
Screw
9
Installing the vanishing edge™ Strainer
NOTE: If you are installing a garbage disposer (not supplied), do not install the strainer assembly .
You will need to purchase a special adaptor that will replace the flange from your garbage disposer.
The flange adaptor is available from the manufacturer. Install the garbage disposer according to the
manufacturer’s installation instructions replacing the flange for the adaptor.
- Apply a small amount of plumbers putty (not included) in the notch
around the drain hole of the sink (A) .
- Connect the upper strainer body (3) and the strainer ring (4), and insert
them into the drain hole from the top of the sink (A) .
- Connect the strainer gasket (5) and lower strainer body (6), and insert
them into the drain hole from underneath the sink (A) .
- Insert the strainer screw (2) through the entire assembly, from the upper
strainer body (3) to the lower strainer body (6). Tighten with a flathead
screwdriver .
-
Connect the plastic flange (7) and the tail pipe (8), and thread the
connecting nut (9) through the tail pipe and flange up to the lower
strainer body (6) . Tighten the connecting nut by hand .
The plastic flange (7), tail pipe (8), and connecting nut (9) are not supplied.
1
2
A
3
4
5
6
7
8
9
Not supplied
